Saeco RI9833/11 User Manual download pdf (Page 31)

• 31 •

English

At this point the button “ ” is program-

med; each time it is pressed and released,

the machine will brew the same amount

of co ee that was just programmed.

Stand-by

The machine is designed for energy sa-

ving. The machine automatically turns o

after 60 minutes of inactivity.

The“

“ button blinks when the machine

is in stand-by mode.

Note: During the turning o

phase, the machine performs

a rinse cycle, if a co ee product has

been brewed.

Warning: When turning the machine

on after it has been turned com-

pletely off, the machine will be in

stand-by mode

To turn the machine on again simply press

the STAND-BY button (if the power but-

ton is set to “I”). In this case the machine

will go through the rinse cycle only if the

boiler is cold.

COFFEE BREWING

Note: Should the machine not

brew co ee, make sure that

the water tank contains water.

Before brewing co ee, check

the lights on the display and

on the control panel. Check that

the water tank and the co ee bean

hopper are full.

Leave the selector on the

co ee position “

” during the

dispensing phase.

Before brewing the coffee,

adjust the height of the di-

spensing spout according to your

needs, and select the aroma or the

pre-ground co ee.

The machine allows slight adjustments to

the co ee grinder to adapt it to the kind

of co ee used.

To make any adjustment, press and turn

the knob inside the co ee bean hopper.

Press and turn the knob by one notch at

a time and brew 2-3 cups of coffee; this

is the only way to notice differences in

grind.

The reference marks inside the coffee

bean hopper indicate the grind setting.

There are 5 di erent grind settings to cho-

ose from with the following references:

Large Mark - Coarse Grind

Small Mark - Fine Grind.

Adjusting the Coﬀ ee Length

The machine allows you to adjust the

amount of brewed coffee according to

your taste and/or the size of your cups.

Each time the

“ ”

or

“ ”

buttons are

pressed and released, the machine brews

a pre-set amount of co ee, as per factory

settings. This amount may be reprogram-

med to your taste. Each button may be

individually programmed for a specific

brew setting.

As an example, the following procedure

describes the programming of the but-

ton“

”, which is normally associated

with espresso co ee.

• Place a cup under the dispensing

spout.

•

Hold the

“ ”

button pressed for 5

seconds to enter the programming

mode; the button

“ ”

blinks together

with the lights of the display shown in

the  gure and the co ee will start to

be brewed. These light signals remain

active during the whole cycle.

• Press the “ ” button again when the

amount of co ee in the cup reaches the

desired level.

Blinking

Steady on

Steady on

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 87 88

Comments to this Manuals

No comments