Saeco Espresso Operations Instructions download pdf (Page 15)

Maintenance & Cleaning Tips

1 | Starting the Machine

1 Lift and remove the water tank.

2 Fill to the MAX level.

3 Connect power and press power switch on the

back.

• All buttons blink.

• When the two coffee buttons light up, the

machine is ready for use.

2 | Priming the Water Circuit

1 Place a container under the steam/hot water

wand and open the steam/water knob.

2 Press the long coffee brew button.

3 Wait for a regular jet of water from the steam/

hot water wand. The dispensing phase will

automatically end.

• When the two coffee buttons light up, the

machine is ready for use.

5 | Dispensing Hot Water

1 Place an empty container under the steam/hot

water wand and open the steam/water knob.

2 Press down the long coffee button.

3 Press the coffee brew button to stop the water

dispensing and close the steam/water knob.

6 | Dispensing Steam &

Preparing a Cappuccino

1 Press the steam button. When steam button is

lit the machine is ready to steam.

2 Place an empty container under the steam/hot

water wand and open the steam/water knob

briey.

3 Release water until only steam comes out.

Close the steam/water knob and remove the

container.

4 Place container half lled with milk so the

steam/hot water spout is just below the milk

surface and turn the steam/water knob. To

correctly froth milk, move the container slowly

downwards to produce a creamy dense froth.

5 Once the desired result has been achieved,

close the knob.

6 It is necessary to reduce the temperature of

the boiler following frothing. Push the steam

button, all buttons will ash. Place an empty

container under the steam/water wand, turn

the steam/water knob and push the long

coffee brew button - a stream of water will be

dispensed and will stop automatically.

Cleaning the Steam/Hot Water Wand

After using the steam/hot water wand,

dispense steam for some seconds. Clean the

steam wand with a clean damp cloth.

Cleaning the Brew Unit

Dispense a long coffee without inserting the

capsule every week to clean the brew unit.

Cleaning the Capsule Waste Drawer

Remove the capsule waste drawer and the

cup grill. Remove the top drawer to take out

the used capsules and drain the drip tray.

Clean and dry both parts before putting them

back.

Descaling

Limescale normally builds up with use of the

appliance.

The machine needs descaling every 3-4

months and/or whenever a reduction in water

ow is noticed.

Please see user manual for instructions on

descaling.

Cleaning the Pannarello

The pannarello must be removed and

completely washed once nished frothing.

3 | Espresso Coffee

1 Ensure loading lever is back in off position.

2 Position a cup under the dispensing spout.

3 Lift the capsule compartment door, insert

capsule and close.

4 Pull the loading lever forward until it stops.

5 Press down the espresso coffee brew button for

extraction to commence.

• Machine will automatically stop when

espresso is ready.

6 Push loading lever back to off position.

4 | Long Coffee

1 Ensure loading lever is back in off position.

2 Position a cup under the dispensing spout.

3 Lift the capsule compartment door, insert

capsule and close.

4 Pull the loading lever forward until it stops.

5 Press down the long coffee brew button to

start.

6 Press the long coffee brew button again if you

wish a shorter coffee than preset.

• The coffee length can be personalised.

Please refer to manual.

7 Push the loading lever back to off position.

1 2 ... 10 11 12 13 14 15

Comments to this Manuals

No comments